Framing A Pocket Door New Construction

Each manufacturer is slightly different so it s best to look up the specification or buy the frame before you frame the wall.

Framing a pocket door new construction.

Finish the joints with drywall tape and several coats of drywall compound. Be sure to screw the brackets into the studs. The rough opening for one of their pocket door frames is two times the door width plus an inch 2 door width 1 inch for the width and 5 inches plus the door height for the header height. Use screws when attaching the finished jamb to the steel studs on the pocket side of opening just in case you need to remove the door for adjustments in the future.

Glue and screw together the 2 by 4s to build a pony wall a smaller non load bearing wall for hanging the track for the pocket doors. To install a pocket door start by removing the existing door and the drywall on one side of the wall. The extra 3 4 inch allows for a jamb on the side of the door opposite the. This makes a room more versatile since it can be closed off from the rest of the house when necessary.

Before you start framing a wall to accept a pocket door you ll need to choose a pocket door frame. Next install the slider track using the rails that came in your pocket door kit. Framing a pocket door refers to the first stage of installing a concealed door. Plumb both jambs with the door.

Reinstall the door and then install the door guides on the inside and outside of the door at the mouth of the pocket. Remove the door and then install drywall over the door pocket using construction adhesive and 1 inch drywall screws. Use a stud finder to locate and mark the stud locations then hammer a nail on the center leaving roughly 1 8 inch sticking out. Make sure the frame is level.

Once the wall. Remember to keep a minimum of 3 16 clearance between the jamb and the door. Then cut the exposed studs to make room for the new framing. We like the pocket door frames that johnson hardware sells.

This is where the frame header brackets will rest. Attach to the ceiling by screwing through the frame into the ceiling joists. Mount the split stud at a distance equal to the width of the door plus 3 4 inch from the trimmer framing the door opening.